Shop – Slick Tools LLC

SnapNrack Array Edge Screen Fastener

Marshall — Thu, 03 Sep 2026 12:18:27 +0000

These clips provide a secure, removable attachment between wire mesh critter guard fencing and solar PV module frames.

CritterBlok™ Solar Animal Guard Clip V2 (box of 50)

Marshall — Fri, 17 Jul 2026 10:35:39 +0000

For attaching wire mesh fencing to solar panels when strength and durability are your top priorities.

Bender Hook

Marshall — Fri, 16 Jan 2026 19:40:18 +0000

Hook for pulling wire mesh through an AG Bender. Fits all model AG Benders.

AG Bender Spindle (service part)

Marshall — Fri, 16 Jan 2026 19:40:15 +0000

Spindle which sides into a roll of wire mesh and mounts to the AG Bender. This part does NOT include grooves or retaining rings like earlier Benders; those parts are not necessary when using the Bender without Spindle Adapter Pegs (which are also discontinued). Fits all model AG Benders.

9/64 Hex Key

Marshall — Fri, 16 Jan 2026 19:40:14 +0000

Hex key stored with AG Bender for tightening Spindle Adapters.

AG Bender Angle Adjust Arm (pair)

Amber Fuller — Fri, 16 Jan 2026 19:40:09 +0000

One pair of angle adjust arms and associated hardware, which allow adjustment of the wire mesh bend angle. All required hardware included. Fits AG Bender 7.0 and up. Click here for help identifying your AG Bender model. Assembly Instructions Step 1: Gather your fasteners and parts Step 2: Angle Adjust Arm Step 3: Clevis Pin

AG Bender Sprocket Assembly

Amber Fuller — Fri, 16 Jan 2026 19:40:07 +0000

Sprocket, bracket and hardware which help guide wire mesh into the Bender. One kit includes a single sprocket and associated parts; two kits required to replace both sprockets on a Bender. Can be used on either side. Attachment hardware included. Fits AG Bender model 7.5 and up.

AG Bender Spindle Support Plate (reinforced)

Marshall — Fri, 16 Jan 2026 19:40:05 +0000

Triangluar plastic plate which holds the Spindle. Reinforcement to the hook area is pre-installed. You must select the side you need; Side A is the fixed side of the Bender (cannot slide on strut channel); side B is the adjustable side (w/ red width adjustment knobs). NOTE - Do not choose A/B based on decals; they have changed position over time. Fits AG Bender 7.0 and up.

AG Bender Conduit Clamp

Marshall — Fri, 16 Jan 2026 18:45:48 +0000

Set of parts which attach the the AG Bender to strut channel rails. Choose a side: Side A is for the non-adjustable side of the Bender (no red knobs); side B is for the adjustable side (with knobs). Kit includes one clamp; note a complete Bender uses 2 clamps per side (4 total).Fits AG Bender 7.0 and up.

AG Bender™ 7 – Refurbished

Marshall — Fri, 07 Jun 2024 15:35:51 +0000

Our used AG Benders are rental units that have been restored to like-new functional condition. They carry the same warranty as a brand new Bender.